No products in the basket.
Remotes & Buttons, Smart Controllers
Fibaro Button (Blue)
Availability:
Only 1 left in stock
The FIBARO Button is a compact, battery powered Z-Wave Plus device that allows you to control devices and run scenes in your Z-Wave network.
- Completely wireless
- Z-Wave Plus certified
- Supports 6 different actions/scenes
- Available in multiple colours (white, black, red, blue, yellow)
$78.00
Only 1 left in stock
CompareProduct Details
The FIBARO Button is a compact, battery-powered Z-Wave Plus device which allows you to manually activate and deactivate devices within your Z-Wave network and to activate scenes defined in your Z-Wave gateway.
The FIBARO Button supports up to 6 different actions/scenes which are triggered with one to five clicks or by holding the button down. In panic mode, each press of the button results in triggering of the emergency scene.
Designed to be small and light, the FIBARO Button can be conveniently mounted on any surface and in any location (eg. beside the bed or under the desk)
Note: This device may be used with all devices certified with the Z-Wave Plus certificate and should be compatible with such devices produced by other manufacturers.
FIBARO Button is a Security Enabled Z-Wave Plus product and a Security Enabled Z-Wave Controller must be used in order to fully utilize the product.
Technical Specifications
|
RF Protocol
|
Z-Wave Plus (500 series chip)
|
|
RF Frequency
|
921.42Mhz – AU/NZ ?approved RF for Z-wave
|
|
Power
|
ER14250 ? AA 3.6V
|
|
Operation Range
|
Up to 40m indoors (with no obstacles)
|
|
Application
|
Indoor use only
|
|
Operation temperature
|
0 ~ 40 ?C
|
|
Storage temperature
|
?10 ~ 50 ?C
|
|
Weight
|
80g
|
|
Dimensions
|
34mm x 46mm (height x diameter)
|
|
Housing
|
ABS
|
Related products
-
Smart Lighting, Switches and Relays
Fibaro Single Switch 2
The Fibaro Z-Wave Single Switch 2 is a wireless Z-Wave module which can control appliances or lighting up to a maximum load of 2.0kW.
- Control the ON-OFF function of a circuit remotely or using a wall switch
- Compatible with all Z-Wave networks
- Acts as a repeater expanding your Z-Wave network
- Wide range of compatibility with existing light fittings and does NOT require expensive cabling
- control loads up to 2kW (8A)
The main differences in the FGS-213 are:
- Z-Wave Plus certification
- Has power monitoring
- 230V powered only (this is the same as the FGS-212)
- No dry contacts – this is important. It means that the new FGS-213 cannot be used to control low voltage systems such as garden lights and irrigation, or where you want a pure volt-free switch such as alarm panels and garage door controls.
SKU: DHS-LIT-SWW-FIB-012 -
Dimmer Modules, Smart Lighting
Fibaro Dimmer 2
The Fibaro Z-Wave In-Wall Dimmer 2 (FGD-212) is the newest version of a popular wireless controller designed to operate behind a wall switch.
- Control the level of illumination of your light remotely or using a manual button (in two and three way configurations)
- Implemented algorithm of smart light source detection
- Acts as a repeater expanding your Z-Wave network
- Wide range of compatibility with existing light fittings and does NOT require expensive re-wiring
- Active power and energy metering functionality
- Works with various types of manual buttons
- Active element: semiconductor electronic switch
SKU: DHS-LIT-DMW-FIB-02 -
Smart Controllers, Wall Mounted Controllers
Fibaro Swipe Pad White
FIBARO Swipe is a wireless, battery powered gesture-controlled pad that allows you to activate Z-Wave scenes or commands with a simple wave of the hand.
FIBARO Swipe has the appearance of a small tablet but instead of a touchscreen, it uses sophisticated motion identification technology to respond to six distinct hand gestures including four directional swipes (up, down, left, right), and two circular motions (left, right). A single gesture or a combination of gestures may be used ? for example, swipe ?down? to turn off the lights, ?up? to open your blinds. With four short swipes, the living room is transformed into a home theater! Swipe?s only limit is your imagination.
- Z-Wave Plus certified contactless gesture control
- May be used with wet or dirty hands ? e.g. turn on the lights in the kitchen or bathroom without getting the switches or wall dirty
- Endless control possibilities ? e.g. wave goodbye to activate your ?going out? scene, swipe up to raise the volume on your sound system, swipe down to close difficult to reach skylight windows, reach out your hand from bed in the morning to activate your coffee machine
- Endless placement possibilities ? e.g. visible on the dresser or a wall with your favourite family photos, or hidden away under the kitchen counter or coffee table
- Powered by 4xAA batteries or Micro-USB giving you ultimate flexibility
- Available in black or white
SKU: DHS-CON-SCON-FIB -
Smart Power, Window Automation
Fakro Z-Wave W/Chain Winder15V
The?FAKRO Z-Wave W/Chain Winder 12V?is highly recommended for rooms with hard to reach windows. An automated system that controls ventilation openings can contribute significantly to maintaining a healthy and comfortable indoor climate. The European engineered, manufactured and certified FAKRO Z-Wave Chain Winder is the perfect solution to inaccessible windows and centralised managed buildings with automated natural ventilation.
- Program in conjunction with the?FAKRO ZWMP Weather Module, for automated window closing upon detecting rain and windfall
- Remote control functionality for ease of use
- Overload protection
- Easily programmable to communicate with compatible Z-Wave gateways
- Automatic switch-off once fully extended
SKU: DHS-WIN-WO-FKR-12
